Banner PBT26U Instrukcja Użytkownika Pobierz pdf (Strona 2)

Fiber Installation Instructions

Banner Engineering Corp. 9714 Tenth Ave. No., Minneapolis, MN 55441 Telephone: (763) 544-3164 FAX: (763) 544-3213

D12 Series sensors for

use with plastic ﬁber optic

assemblies include sensors

with the letters FP in their

model number sufﬁx.

Install the plastic ﬁber optic assembly(s)

as follows:

1) Prepare the sensor ends of the ﬁbers

(see page 1, bottom).

2) Unlock (slide up) the ﬁber gripper and

insert the small ﬁber adaptor into the

ports as far as it will go.

3) Gently insert the prepared plastic ﬁber

sensor ends into the ports as far as they

will go. Slide the ﬁber gripper down to

lock.

D12 Series

OMNI-BEAM, MAXI-

BEAM, VALU-BEAM,

and Q45 Series sensors for

use with plastic ﬁber optic

assemblies include sensors

with the letters FP in their

model number sufﬁx.

OMNI-BEAM, MAXI-BEAM, VALU-BEAM,

Q45 Series

Install the plastic ﬁber optic assembly(s)

as follows:

Prepare the sensor ends of the ﬁbers

(see page 1, bottom).

Loosen the clamp screw on the sensor

face.

Follow steps 1-3 in the drawing, right.

MINI-BEAM, ECONO-BEAM

Install the plastic ﬁber optic

assembly(s) as follows:

Prepare the sensor ends of the

ﬁbers (see page 1, bottom).

Loosen the clamp screw on the

sensor face.

Follow steps 1-3 in the

drawing, right.

MINI-BEAM and ECONO-

BEAM sensors for use with

plastic ﬁber optic assem-

blies include sensors with

the letters FP in their model

number sufﬁx.

1 2

Komentarze do niniejszej Instrukcji

Brak uwag

Banner PBT26U Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Światłowody Banner PBT26U