Banner PresencePLUS Interface Modules Instrukcja Użytkownika Pobierz pdf (Strona 2)

SCM Strobe Control Module

page

Banner Engineering Corp. • Minneapolis, U.S.A.

Website: http://www.baneng.com • Tel: 763.544.3164

Light 1

9-pin D-sub connector for

connection to LED light source

Rise/Fall 1

slide switch selection of low to high

("Rise") or high to low ("Fall")

trigger input signal

Test 1

Momentary push button

manual trigger

Output Channel #1

Pulse Width 1

8-segment DIP switches for binary

selection of output pulse duration

Light 2

9-pin D-sub connector for

connection to LED light source

Rise/Fall 2

slide switch selection of low to high

("Rise") or high to low ("Fall")

trigger input signal

Test 2

Momentary push button

manual trigger

Output Channel #2

Pulse Width 2

8-segment DIP switches for binary

selection of output pulse duration

Fuse

Removable terminal block

for connection of 24V dc module

power and trigger input signals

Wiring

Power Input 24V dc ±5% is connected between “+24V DC” and “DC GND” on

the removeable terminal block (see Figure 1). Power supply model

PSC-24(E) is recommended for powering the SCM, and is available

as an accessory (see page 4 and data sheet P/N 67466).

Trigger Inputs The trigger signal must be a voltage between 5 and 12V dc. The

source of a trigger signal must be capable of supplying up to 10 mA.

2-wire shielded cable must be used. One 3 m (10') trigger cable is

supplied. Connect as indicated above, for each strobe channel used.

Figure 1. SCM Strobe Control Module feature identification

1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag

Banner PresencePLUS Interface Modules Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Przekaźnik Banner PresencePLUS Interface Modules